stihl 036 carb adjustment instructions can also be found HERE
It is also worth viewing or downloading the free stihl carburetor manual HERE
Free stihl 036 parts list is HERE
Also the full service manual is a good workshop repair PDF that can be viewed a page a time for free or downloaded onto any device and printed off, which is available HERE
To adjust or tune the Stihl 036 Chainsaw Carburetor follow these simple steps:
(LA) Idle Speed screw – This controls the engine speed at idle. If set too low, the saw will die. If set too high the chain will run. This is dangerous.
(L) Low speed adjustment screw – This is the low speed jet. This is the adjustment that controls the air/fuel mixture at idle. Adjust this screw too rich and the chainsaw will blubber and die at idle speed. Adjust this screw too lean and the engine will starve. The saw will race or surge. An extremely lean adjustment will also cause the engine to die.
(H) High speed adjustment screw – This is the high speed jet. This is the adjustment that controls the air/fuel mixture at high RPMs. Adjust this screw too rich and the chainsaw will blubber, too lean and it will over rev
Safe Basic Settings
Screws (H) & (L) – Turn the adjustment Screws (H) & (L) down onto their seats (clockwise). Back them off 1 complete turn (counter-clockwise)
Screw (LA) – Turn (LA) Idle Speed screw until the chain stops. Then turn counter-clockwise one quarter of a turn.
Fine Tuning – Screw (L)
Erratic idling behavior; poor acceleration – Idle setting too lean; turn low speed adjusting screw (L) counterclockwise until engine runs and accelerates smoothly. Readjust screw (LA).
Exhaust smokes at idle speed –Idle speed setting too rich; turn low speed adjusting screw (L) clockwise until engine speed drops. Then turn screw back one quarter turn and check that engine still accelerates smoothly when you open the throttle. Readjust screw (LA).
If you can not get the saw to start with regular 50:1 mix or regular gas for that matter you have other problems and ether isn’t going to help matters. Just squirt a little gas directly into the carburetor and if it doesn’t start then adjust your idle screw.
Please login first to submit.